If the above recommendations still have not resolved the irregular POST, disconnect the riser board (if applicable) and each of the expansion cards. Many motherboards may also have additional cables connected to them to supply power to the fans. Your power supply should have at least one cable going to the motherboard.All disk drives should have a data cable and power cable connected to them.
Verify all the cables are securely connected to the computer and that there are no loose cables by firmly pressing in each cable. If a fan has failed (especially the heat sink fan for the CPU), your computer could be overheating or detecting the fan failure, causing the computer not to boot. Make sure all fans are running on the computer.
#WINALIGN NOT ENOUGH STORAGE CODE#
If your beep code is not listed, continue troubleshooting. These beep codes are meant to help identify which computer component is failing or bad. You can also check your motherboard or computer documentation for information on the beep codes. If you are receiving a sequence of beeps, see the beep code page for a listing of different beep codes and their explanation. Disconnect your power cables from any power strip or UPS (uninterruptible power supply) and connect the computer directly to a known good wall outlet. If the computer is not getting enough power or the power is getting interrupted, the computer can encounter problems. If the computer has never beeped, keep the monitor or display connected to see if any change occurs. Turn on the computer and see if it beeps normally. Remove everything from the back of the computer, except the power cable. Reboot the computer and see if anything changes.
If any USB devices ( iPods, drives, phones, etc.) are connected, disconnect all of them as well. Remove any disks, CDs, or DVDs that are in the computer. Either the new hardware is not compatible with your computer, a system setting needs to be changed, or the new hardware is defective.
If your computer works after removing the new hardware, it can mean a few things. If any new hardware was recently added to the computer, remove that hardware to make sure it is not causing your issue. While working inside the computer, it's highly recommended you be aware of ESD (electrostatic discharge) and its potential hazards. Some of the steps below recommend removing physical parts from inside the computer.
0 kommentar(er)
